cr-10-v3-marlin-config issueshttps://git.pickysysadmin.ca/FiZi/cr-10-v3-marlin-config/-/issues2021-05-01T21:26:49Zhttps://git.pickysysadmin.ca/FiZi/cr-10-v3-marlin-config/-/issues/1Filament load and unload is not optimized for direct feed titan2021-05-01T21:26:49ZGhost UserFilament load and unload is not optimized for direct feed titanThe load and unload values are set for bowden systems rather than direct feed ie.:
FILAMENT_CHANGE_UNLOAD_LENGTH
FILAMENT_CHANGE_FAST_LOAD_LENGTH
I found these to work better with the titan on my V3 CR-10
```
#define FILAMENT_CHA...The load and unload values are set for bowden systems rather than direct feed ie.:
FILAMENT_CHANGE_UNLOAD_LENGTH
FILAMENT_CHANGE_FAST_LOAD_LENGTH
I found these to work better with the titan on my V3 CR-10
```
#define FILAMENT_CHANGE_UNLOAD_FEEDRATE 10 // (mm/s) Unload filament feedrate. This can be pretty fast.
#define FILAMENT_CHANGE_UNLOAD_ACCEL 25 // (mm/s^2) Lower acceleration may allow a faster feedrate.
#define FILAMENT_CHANGE_UNLOAD_LENGTH 40 // (mm) The length of filament for a complete unload.
// For Bowden, the full length of the tube and nozzle.
// For direct drive, the full length of the nozzle.
// Set to 0 for manual unloading.
#define FILAMENT_CHANGE_SLOW_LOAD_FEEDRATE 6 // (mm/s) Slow move when starting load.
#define FILAMENT_CHANGE_SLOW_LOAD_LENGTH 0 // (mm) Slow length, to allow time to insert material.
// 0 to disable start loading and skip to fast load only
#define FILAMENT_CHANGE_FAST_LOAD_FEEDRATE 6 // (mm/s) Load filament feedrate. This can be pretty fast.
#define FILAMENT_CHANGE_FAST_LOAD_ACCEL 25 // (mm/s^2) Lower acceleration may allow a faster feedrate.
#define FILAMENT_CHANGE_FAST_LOAD_LENGTH 20 // (mm) Load length of filament, from extruder gear to nozzle.
// For Bowden, the full length of the tube and nozzle.
// For direct drive, the full length of the nozzle.
```