Tags give the ability to mark specific points in history as being important
- Sort by
- Name
- Oldest updated
- Last updated
-
2.0.7.2_2020-11-10-1103Release 2.0.7.2_2020-11-10-1103
Updated for Marlin 2.0.7.2
Enabled
POWER_LOSS_RECOVERY -
2.0.7.1_2020-10-10-1328Release 2.0.7.1_2020-10-10-1328
Updated for Marlin 2.0.7.1 and started building non-BLTouch versions of the firmware for those with out a BLTouch
-
2.0.7_2020-09-28-2111Release 2.0.7_2020-09-28-2111
- Updated for Marlin 2.0.7
- Hotend max temperature is now 260c per the specs
Pre-compiled firmware: 2.0.7_2020-09-28-2111.hex
-
2.0.6_2020-08-19-1222Release 2.0.6_2020-08-19-1222
Disable RESTORE_LEVELING_AFTER_G28
I have the following gcode in OctoPrint that runs before a print job to load the mesh leveling configuration:
M420 S1 Z10 ; Get and/or set bed leveling state, S1 = Enabled, Z10 = reduce leveling correction after this many levelsThis makes it so when I tell OctoPrint's Bed Visualization Plugin to "Level the bed" it doesn't load the existing mesh and then level. It will instead level from a blank slate like it should.
Use
2.0.6_2020-08-19-1222.hexin\Compiled Firmwaresfor this release